3.0 GHz Spectrum Analyzer GSP830 User Manual

3.0 GHz Spectrum Analyzer GSP830 User Manual
Pages 181
Views 1,689
Downloads : 1 times
PDF Size : 4.4 MiB

Summary of Contents

3.0 GHz Spectrum Analyzer GSP830 User Manual

  • SAFETY INSTRUCTIONS 7 • Use only mating connectors, not bare wires, for the terminals. • Do not block or obstruct the cooling fan vent opening. • Do not perform measurement at a power generating source or building installation site (Note below). • Do not disassemble the GSP-830 unless you are technically qualified. (Note) EN 61010-1:2001 specifies the measurement categories and their requirements as follows. The GSP-830 falls under category II.• Measurement category IV is for measurement performed at the source of low-voltage installation. • Measurement category III is for measurement performed in the building installation. • Measurement category II is for measurement performed on the circuits directly connected to the low voltage installation. Power Supply WARNING • AC Input voltage: 100 to 240 V AC, 50/60Hz, 90W maximum • DC Input voltage: 12V DC, 40W maximum • The power supply voltage should not fluctuate more than 10%. • Connect the protective grounding conductor of the AC power cord to an earth ground, to avoid electrical shock. Battery CAUTION • Rating: 11.1V lithium-ion battery pack x 2 • Turn off the main power switch before installing or taking out the battery packs. Fuse WARNING • Fuse type: T1.6A/ 250V, time-delay, 5x20mm glass • To ensure fire protection, replace the fuse only with the specified type and rating. • Disconnect the power cord before fuse replacement. • Make sure the cause of fuse blowout is fixed before fuse replacement. Cleaning the GSP-830 • Disconnect the power cord before cleaning. • Use a soft cloth dampened in a solution of mild detergent and water. Do not spray any liquid into the GSP-830. • Do not use chemicals or cleaners containing harsh products such as benzene, toluene, xylene, and acetone. Operation Environment • Location: indoor, no direct sunlight, dust free, almost non-conductive pollution (Note below) • Relative Humidity: < 90% • Altitude: < 2000m • Temperature: 18°C to 28°C Storage Environment • Location: indoor • Relative humidity: < 85% • Temperature: 0°C to 40°C