3.0 GHz Spectrum Analyzer GSP830 User Manual

3.0 GHz Spectrum Analyzer GSP830 User Manual
Pages 181
Views 1,612
Downloads : 1 times
PDF Size : 4.4 MiB

Summary of Contents

3.0 GHz Spectrum Analyzer GSP830 User Manual

  • GETTING STARTED 23 SDRAMPass FailF 3 Internal SDRAM for running the system code RTCPass FailF 4 Internal real time clock for configuring the date and time Functionality Check • This section assumes that the GSP-830 is already powered up (page20). • Before operating the GSP-830 in a new environment, run these steps to make sure it is functionally stable. 1. Feed a signal Input a signal to check if the GSP-830 correctly shows the waveform on the display. There are two ways to feed an input signal. Feeding the DUT signal If the DUT is already available, connect the output signal to the RF input terminal. The signal amplitude must be less than +30dBm. Feeding the internal auxiliary signal You can also use the internal auxiliary signal, 100MHz/−30dBm. No cable connection is required in this case. Activate the signal by pressing the System key→F4 (Aux Sig On). Aux SigOn OffF 4System