GSP-830 User Manual 152 Connect Software This section assumes that the software is already installed. Configure interface USB slave or RS-232C is acceptable. Configure USB No need to configure anything on the GSP-830 side. Just connect the type B mini USB cable to the rear panel. Configure RS-232C 1. The RS-232C configuration can be checked from the system menu. Press the System key. System 2. Press F3 (Serial Port). Serial Port..F 3 3. The RS-232C port configuration appears. Configure the PC according to this setting. Baud: 57600 Parity: None Stop bit: 1 Data bit: 8 Stop1F 3Baud57600F 1ParityNoneF 2Data8F 4 4. Connect a 9 pin, male RS-232C cable to the rear panel connector. Invoke software PC operation 1. Invoke the software from the startup menu in the PC.